Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

How does the ND66 operate?

Resolution: ND66PD (ANSI F91) Store Lock Key in either lever locks or unlocks both levers. :

What does an LX switch monitor?

Resolution: The LX switch monitors whether the latchbolt is extended or retracted.:

Is Von Duprin's EL device rated for continuous duty?

Resolution: The Von Duprin EL devices are rated for continuous duty.:

8200 Pushutton Console Dimensions

Resolution: Length 7 5/8 " width 10" Height (Rear 4") (Front 3/8"):

What is the 900-BBK?

Resolution: The 900-BBK is a battery backup board with batteries for the PS900 series power supplies.:

Can you cut the EL conversion kit - 3' base plate to fit a 30" 9947 device?

Resolution: You need to order the EL98/9947 or 3' EL conversion kit. This will fit on 28 1/8" minimum door opening on two vertical x vertical rod device doors.:

How do you route the wires for an E996L trim through the exit device?

Resolution: The wires run through the device out to the EPT. See step 7 on page 5 of E996L instructions.:

Can a 2030 closer be put on a 24" door leaf?

Resolution: The 2030 can be mounted on a 24" wide door that is hung on butt hinges by using the following Special Templating (ST)Butt Hinges - 2030 x ST-0600 (24" door minimum).Special Track and Tem...:

Can the XX-V, 19-V, 24-V or 25-V extension rod be used on the bottom rod?

Resolution: The extension rod could be used either on the top or bottom rods.:

Why doesn't the cover depress the Tamper Switch on my Main PCBA?

Resolution: The Main PCBA and Inside Cover were revised to incorporate a more robust switch in a different location on the board. See the attached document, Tamper Switch and Cover Comparison , for a comp...: