Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What special template (ST) is used with a 5030 closer and a GJ100 with offset pivots/butt hinges?

Resolution: A special template (ST) is no longer required for the GJ100. Special template ST-9401 (from GJ) was the old nomenclature for the special jamb bracket.The CJ bracket is required when using a GJ-Ives...:

What is the solenoid coil resistance on the Chexit solenoid?

Resolution: Only applicable for solenoid driven Chexit devices shipped from the factory prior to 8-24-2015; Chexit solenoid coil resistance between the green and orange wires is 110-140 ohm and betw...:

What cams do we use on the L9060?

Resolution: The straight cam should be installed on the outside cylinder and the clover cam on the inside.For Schlage Conventional mortise housings use the Following cam part numbers:Straight Cam L583-476 – F...:

Can I get the T series with a Schlage Full Size Interchangeable core?

Resolution: The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC:

Which Falcon SC closer is the closest match to a LCN 4040?

Resolution: The Falcon SC 71:

How many compression anchors are provide per jamb on DW-Series frames?

Resolution: For compression anchor details refer to the “ANCHORING SYSTEMS” section in the Steelcraft Tech Data Manual.Anchor Quantities: • 1 compression anchor per jamb through 9"depth • ...:

Will the 996L-NL R/V work with a concealed vertical rod device?

Resolution: The 996L-NL R/V trim is the same for rim, surface and concealed exit devices so this will work.:

FE 210 Can not be programed with HHD

Resolution: Check the Deadbolt switch and cam timing. Initial programming should be performed with bolt retracted. If the unit is properly timed the deadbolt cam should activate the internal switch allow...:

Can the Schlage danmark levers be added to the 996?

Resolution: The Schlage Danmark levers are not available on the Von Duprin 996L lever trim.:

Are there extension rods for 8827?

Resolution: There are four different sizes of extension rod for 8827 exit device: 8827, 12" extension rod = 051701-finish 8827, 24" extension rod = 051703-finish 8827, 36" extension rod = 050660-finish 8827, ...: