Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Is the 23-030 a small format or full size core?

Resolution: The 23-030 is a Schlage Full size interchangeable core. :

Resolution: 4. PIM400/AD400 COM400 plug could be damaged! The small pins in the Main PCB board connection for the RF COMM board can get bent during installation of the RF COM400 board. If the PINs are be...:

Are the Aluminum Geared Continuous Hinges Fire Rated for 3 hours?

Resolution: All Ives Aluminum Geared Hinges excluding the 157XY are tested and approved UL 10C (90 minutes).All Ives Aluminum Geared Hinges excluding the 157XY are certified to ANSI 156.26, Grade 1:

What is the diameter of the 04-060 AL rose?

Resolution: The rose measures 3-7/16" diameter.:

What is the part number for the ND Series rose?

Resolution: 03-042 is the part number for the inside or outside rose.:

What finishes are available on the decorative plate for AD / CO

Resolution: Available Finishes: 626 Satin Chrome Standard. Please consult Customer Care for 605 Bright Brass or 643E Aged Bronze.Click - for data sheet for AD 400, includes pictures of all finishes for AD...:

Can I mount an LCN Cush closer with an GJ overhead stop?

Resolution: It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.:

Can the 4854 mullion be ordered as prepped for two 6111 electric strikes?

Resolution: There is not enough room to install two 6111 electric strikes back to back in 4854 mullion.:

What is the part number for the 99 series NL drive screw?

Resolution: The part number for 98/99 series NL Drive Screw is 970441-89. The NL Drive Screw is also available in package of ten, part number 090074-00 NL Drive Screw can't be substitute with a standard sc...:

Why does a 25 device come undogged when the door closes?

Resolution: The dogging spring in the dogging assembly could be worn or broken or possibly the dogging pin on the device is bent towards endcap of device instead of being perpendicular with baseplate.: