Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Resolution: The E371L-BE trim can be use with 5547-F device.:

Can you add a RX-LC switch to a 98/99 device out in the field

Resolution: You can add an RX-LX with a switch kit, part number 05028.Click - for Installation Instructions: Von Duprin RX RX-LC/S1 Switch Retrofit Kit Installation Instructions for 33A/35A & 98/99 De...:

What special template (ST) is used with a 4020 closer and a deep reveal?

Resolution: The "Regular Arm" allows for 180 degree with reveals up to 2-9/16” or 140 degree with reveals up to 4”The “Long Arm” allows for 140 degree with reveals from over 4” up to 8”ST-2458 will accommodate...:

Can I use a Glynn Johnson 100 with a 4030 pull side mount?

Resolution: The proper solution since it is probably an abusive situation (having to use an auxiliary stop) would be to go to a heavier duty closer such as the 1461, 4011, or 4040XP. For the related 1461 so...:

What is the 23-065?

Resolution: The 23-065 is the conventional cylinder for the ND-Series lever.:

Are the AL locks available with a 5" backset?

Resolution: This is available, specify 41-005 for an extension link that is used with a 2 3/8" latch to effectively make a 5" backset.:

What is the 40-100 multi-tailpiece cylinder kit?

Resolution: The pack is available in all keyways, Everest and Classic families including restricted keyways except Primus. The ALX70 tailpiece is not included in the pack and can be purchased ...:

What does B80 or B140 indicate on an ME closer?

Resolution: The "B" means "Bypass". The "80 or 140" is the degree of door opening from the fully closed position. "B80" means the hold open feature is bypassed (will not hold open) until the door is opened...:

Schlage Express - can an auto-unlock be scheduled for the BE367?

Resolution: You can set a timezone for a user but not an auto-unlock on the BE367:

How do I couple a Hand Held Device to a PIM400

Resolution: If the PIM400 has already been coupled with a HHD, the Coupling process will be disabled and the PIM400 will no longer go into its Coupling Mode. You must RESET the PIM400 in order to allow (re-en...: