Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Is there a heavy duty arm available for the 4040 mounted pull side?

Resolution: ST2795 allows the the 4040 to be mounted pull side with a solid (heavy duty) arm.:

What would cause a Senior Swing to open only 10 degrees and then close?

Resolution: Issue/Symptom – upon receiving an activation input the Sr Swing gearbox opens only about 10 degrees and then returns to the close position. Unit will never learn opening nor function pro...:

What power supply is required for two EL devices and one LCN auto operator?

Resolution: Von Duprin PS914 x 900-4RL supports two EL with two auto operator.:

Can I use 350 dummy pushbar with 996LDT?

Resolution: To use 350 dummy push bar with 996L-DT you will need the 050140 mounting hardware for standard 1 3/4" door, or 050141 for 2 1/4" door.:

Can we provide a fire rated 98/99 exit device for doors greater than 4' wide?

Resolution: The 98/99-F device provide a fire rating up to 4 feet wide opening only.:

What is the minimum stile for Schlage locks?

Resolution: The minimum stile for each lock will depend on the backset and the rose diameter/escutcheon width. See the Schlage Minimum Stile Requirements for the minimum stile for eac...:

What is the part number for the inside lever on an L9000 lock?

Resolution: The part number is the 09-402, specify the design and finish.:

What is the part number for the Primus pinning kit?

Resolution: 40-070 is the part number for the Primus pinning kit. :

Does Schlage make a mortise lock that the lever on either side retracts the latch and a key on either side retracts the deadbolt?

Resolution: The L9466 Store/Utility Room lock can provide this functionality. Operation: Latchbolt retracted by knob/lever either side. Deadbolt thrown or retracted by key from either side. When the deadbolt ...:

What grade of stainless steel do we use in the levers on L9000 locks?

Resolution: Schlage offers 629 and 630 stainless finishes on levers for the L-Series only. These levers are made of 303 or 304 grade stainless steel.: