Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Does EL or QEL conversion kit for Von Duprin exit devices contain mechanism cover plate?

Resolution: The conversion kit does not contain a new mechanism case cover plate. If a cover plate is desired, you would need the Fire or Less Dogging Cover Plate for EL/QEL conversion kit and Panic cove...:

Will the 8310-853 actuator mount in a single gang or a double gang box?

Resolution: The 8310-853 (T) series actuator will mount to either a single or double gang electrical box.:

Can I use a Glynn Johnson 410 with a 4040 regular (pull side) mount?

Resolution: ST-1630 is required when mounting a 4041 or 4040XP door closer regular (pull/hinge) side with a concealed GJ100 or GJ410 series over head stop.This ST also REQUIRES the use of a 4040-18TJ drop plat...:

Are the danmark levers available in escutcheon trim?

Resolution: The Danmark levers were available in rose trim only.:

What is the part number for T lock tailpiece used with a conventional cylinder?

Resolution: Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:

What is the load for a 059 and 59 handrail bracket?

Resolution: 250 lbf:

Why does my 7500 retract the latch bolt but not re-lock the trim?

Resolution: Tips for changing the function: The NL Drive screw will not be visible when lock body is set to Classroom function There is locktite on the screw that makes it seem like its turned down enou...:

What viewer and knocker combination should be used on a 1 3/4" thick door?

Resolution: 31252U provides the 3125 knocker and the U701 viewer for 1 5/8" - 2 1/8" thick doors.:

Can a 9100 series Benchmark be used on a high traffic exterior door?

Resolution: The recommended application for the 9100 series Benchmark operator is low traffic exterior doors, or low/moderate traffic interior doors. The Benchmark series operator "is not" recommended for use ...:

Can I use the 10-072 strike with a L400 Series lock?

Resolution: Only the 10-079 or 10-078 strike should be used with the L400-Series. :