Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can the Von Duprin EL option be added to any existing 98/99 device?

Resolution: The Von Duprin EL option can be added to any existing 33A/35A, 98/99 series exit devices. :

Can a panic device be converted to a fire-rated device in the field?

Resolution: A standard exit device can't be modified to a fire rated exit device. In order to get a product with the UL fire label, a new device must be purchased. This is a UL requirement.:

Can I make a wireless activated 4640 operator work as alternate action?

Resolution: The 8310-865 RF receiver contacts (N.O. and COM) would connect to terminals 15 & 17 (the alternate action input) on the 4600 operator. The first activation would open the door, the s...:

What is LCN replacement part number for a Dor-O-Matic number 81007-90x?

Resolution: 81007 is the old DOM number for a Sr Swing Motor gearbox. The -90x indicated the Hand, a -901 is RH and a -902 is LH. If you have a 81007-901 - The LCN replacement part numb...:

What functions are available for the E996 trim?

Resolution: E996 trim can be ordered FS or FSE, lever trim must be either L or L-BE. In both situation (E996L or E996L-BE), the electronics lock/unlock the lever. The E996L trim allows for the inst...:

What is a Door Position Switch (DPS) for a Chexit device?

Resolution: A Door Position Switch is a switch and magnet mounted on the door and frame that monitors the door status. If door is held open beyond rearm time or if door is forced open, alarm wil...:

What special template (ST) is used with the 4041EDA and a GJ 814-816?

Resolution: You will need a 4040XP closer with an EDAG arm and use Special Template ST-3448. :

Is the 33-006 cylinder plug available?

Resolution: The 33-006 plug is no longer available.:

What is the part number for the dogging assembly on a 22, 33A/35A, or 98/99 series devices?

Resolution: There is no single part number for a dogging assembly (since August 1998). If you look at the baseplate assembly in the parts manual you will find the dogging shaft, dogging hook, dogging spr...:

Is there a back box for Chexit so they can put the CX module in a remote location?

Resolution: If you need to cut a CX device down it is possible to relocate the CX PCB to an external enclosure. This is done by ordering the CX device as an RCM or Remote Chexit Module. See ...: