Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What mullion is suggest for use with a 2670 double door application?

Resolution: Should use the 4954 or 4954 blank mullion.:

What are the part numbers for the inside and outside knobs for the L series?

Resolution: Inside knob and bushing: 09-402 plus design and finishOutside knob: 09-401 plus design and finish:

What is the part number for an E7500 32D 24VDC FS?

Resolution: Von duprin part # 011456-32:

Are the Falcon EL solenoids rated for continuous duty?

Resolution: The Falcon EL devices can be operated in a continuous duty cycle.:

How do I order a Von Duprin mullion prepped for something other than our standard strikes?

Resolution: To use Von Duprin mullion for something other than our standard strike, order the mullion "Blank" and prep in the field.:

Can I use the 4040/4040XP in high traffic areas?

Resolution: The 4041/4040XP is a heavy duty door closer, designed for high traffic areas.:

Can I add Hex Dogging to my EL33/35A or EL98/99 series exit device in the field?

Resolution: This would require a HD EL Conversion Kit 050384 for a 3' device or 050385 for a 4' device. You will also need a 050117-XX 35A/98 or 050114-XX 33A/99 Hex Dog Conversion kit. :

Are the Von Duprin 6000 series electric strikes rated for continuous duty?

Resolution: All of Von Duprin 6000 series electric strikes have continuous duty solenoids either 12 or 24VDC.:

On a 679-05WD door postion switch, where does this need to be located on the door?

Resolution: Typical positioning would be a few approximately 6 inches above the latch on the door edge. Alternative location could be the door top edge.As far from the hinge side as possible. :

Will the end cap from a 672 or 692 REX Touch bar fit the old 671 Touch bar?

Resolution: NO: End caps for the 672 & 692 REX Touch bars are not compatible with the 671 Touch bar.: