Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Where can I find timing instructions for the Falcon T lock?

Resolution: To verify the timing on a T561, function test the outside lever after locking it. To lock the key should only rotate 180 degrees (Not 360 degrees as Schlage does) A p...:

What is the part # for the 4040 HCush arm?

Resolution: The part number for the 4041/4040XP HCush arm is 4040XP-3049CNS.:

What is the center to center distance on an S200 lock?

Resolution: The dimension from the center of the top hole to the bottom hole is 4".:

Does Falcon make a plate to cover holes when the door is prepped wrong?

Resolution: These items are not available from Schlage or Falcon. There are third party companies such as Don-Jo or Pro-Lok that manufacture cover plates.:

Do we have special templates (ST) for the Falcon line of door closers?

Resolution: The Falcon brand is the economy line, and are not available with special templates. If a special application is required then we recommend to use the LCN brand and any associated special templates.:

What is the part number for the Falcon 8200 (8230/8240) series operator control box?

Resolution: The Falcon 8200 Series control box can be ordered as either an 8230-3462 or an 8240-3462. They are the same part.:

What special template (ST) is used with a 4040 closer, PA mount and a 18" door width?

Resolution: Special Template ST-2338 is used to mount a 4040/4040XP closer mounted Rw/Pa on an 18" door.:

What is the minimum rose dimension that can be used with a Steelcraft 61L lock preparation?

Resolution: The minimum rose that can be used on the 61L (ANSI/BHMA A156.115.18) preparation is 3 7/16".Steelcraft's 61L lock prep (often referred to as the "Squashed Turtle lock prep") is designed for Bored L...:

What replaced the 12-274 deadbolt?

Resolution: There is no direct replacement. This deadbolt was the standard bolt provided for the BC100-Series which was discontinued in 2007.:

What are security jamb anchors?

Resolution: Security anchors are used in DW/K frames located directly above or below strike preparation on door side of frame. Because there are only two points of anchoring, the compression anchor near the ...: