Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Are the old option boards for the PS873 series power supplies still available?

Resolution: Check with customer service for stock availability.:

Will an HID RP40 multi-tech credential reader work with CT5000 or WRI400 and also with AD locksets?

Resolution: Consider a different smart card credential reader from Schlage, one that is data output compatible with AD locksets.:

What is power boost on a Senior Swing or Benchmark operator?

Resolution: Power Boost is a positive latching feature that increases the latch force, to over come building stack pressure or door weather stripping, etc, if the door stops before co...:

What size machine screws are used with thru bolts and a 2-3/4" thick door and a 4040 closer?

Resolution: A 4040 closer mounted with thru bolts on a 2-3/4" thick door would require 1/4-20 X 3-1/2" machine screws.:

What are the voltage requirements for the old Schlage D lever lock?

Resolution: Electrical Requirements for EL or EU Amps .15; Volts 24 AC. (Rectifier must be used) Amps .35; Volts 24 DC. :

What is the power supply needed for the Dor-O-Matic EL devices?

Resolution: PS914 with either the 900-2RS option board for powering 1 or 2 devices or the 900-4RL option board for up to 4 devices.:

What power supply is need for Falcon EL devices?

Resolution: The Von Duprin PS914 power supply with either the 900-2RS or the 900-4RL option board is required.:

What are the amperage and power supply requirements for the Von Duprin Chexit (CX) devices?

Resolution: Chexit motor driven devices shipped after 8-24-2015:You can use 1 Chexit device with PS902, 3 Chexit devices with PS904, and 4 Chexit devices with PS914 or PS906 power supplies with proper gau...:

How long are the rod lengths for the 25-V?

Resolution: The top and bottom rod itself is 35" long standard.:

Why will my EL device not release the solenoid?

Resolution: Try these steps:Disconnect power from the EL device, if the solenoid plunger releases then and issue is with power going into the device.If it still does not release, try to pull the plunger out of...: