Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Why does SMS Express report "Mechanical Key Override" audits when the mechanical key was never used?

Resolution: Ignor "Mechanical Key Override" audits that occur within a few seconds of a vaild accress:

Resolution: If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening.:

What is the minimum top rail required on a door for 1461 Rw/PA?

Resolution: The 1461 Rw/PA requires a 4-3/8" minimum top rail on the door without the use of a drop plate. If top rail is less than 4-3/8" a 1460-18PA drop plate will have to be used.:

What is the M504-413 tool used for?

Resolution: See attachment that describes this tool.:

How many electric strikes can a PS904 run?

Resolution: PS904 x 900-BB can support up to five 6211 electric strikes, running 12VDC.:

Can you mount a 4040XP CUSH with a Flush Transom frame?

Resolution: The 4040 XP CUSH/EDA can be mounted on a Flush Transom frame by using a -419 Flush Panel adapter.:

Can you mount a 2610 series operator on a door with center pivots?

Resolution: ST-2691 is used to mount a 2610 series closer on a center pivoted door. Requires a minimum 40" wide door leaf, and only get about 4 degrees of latch (this is not a recommended application).:

What is the narrowest door a 99 rim, single door can fit on?

Resolution: The Minimum single door opening should be 26.32" and use the 299 or 499F strike.:

How long will the battery back up work for on the PS914-900BBK?

Resolution: Attached table provides how long the battery back up will last with a PS914 power supply. Load (Amp DC) Battery backup time Comments 0.3 Amp 20 hours Continuous load ...:

Can a pull side mounted 1460 open 180°

Resolution: A 1260 Pull Side can be mounted standard template for 180°, frame and trim permitting.: