Zero 55/555 gasket coming loose

The #55 half of this product has a small piece of gasketing that doesn’t stick out so it shouldn’t be an issue; however, what sometimes happens is that sometimes the piece is installed too tight which pulls the gasket out of the housing.  The bottom part of the extrusion can be crimped a little to keep it from sliding down. When this is done the gasket would have to be slid in from the top. The side with the #555 can be repaired the same way.

 

It is suggested that if the above does not work, they could use the pile insert because it has a hard plastic backing and doesn’t flex at all or very little.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.