Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Why is my Von Duprin QEL light flashing red and green?

A red and green flashing LED's on a QEL indicates the device has been tampered with while power was applied, the push pad was pulled out at least three time. Wait 15 seconds and latchbolt will retract again or remove and reapply power to clear condition.QEL devices shipped prior to December 2014 will take up to two minutes to reset.

The push bar being pulled out three times while power is applied causes the lights to flash and the device to stop retracting.

Check to make sure there is no bind of the latch.


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question
qel latch retraction
device has flashing red light
two flash red
qel led status light meanings
can you get cx with qel