Why does the #2 master pin fall out of a cylinder?
A #2 masterpin can fall out when the key used to operate a cross-keyed cylinder is partially inserted or partially removed prior to completing the key rotation. This issue is typically seen in a cross-keyed cylinder with a stack of #2 masterpins in the last chamber. Since multiple chambers are empty and usually with 2 chambers have masterpins a partially inserted (or removed) key can create a shear line allowing the key to rotate. Depending on the key used a #2 masterpin can be pushed into the "bible" and with a partially inserted or removed key the end of the key can't keep the #2 masterpin in the bible thus it falls out.
Solutions:
Fill empty chambers to reduce the chance of creating an unwanted shear line
Review masterkey system and pin chamber 5 instead of 6 if possible along with another chamber
Redesign of the system to eliminate the #2 masterpins in the last chamber, try to use solid pins
Utilize Primus as a partially inserted key will not rotate
Utilize electronic access on the opening where a cross-keyed cylinder is installed
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.