Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

What is an error code E04 on an LCN 4600?

An error - E 04 - is an indication of a constant activation input from either the "Hold Open" switch or a "Wall Activation" switch when the 4600 power is turned on. This condition also occurs when leaving the programming mode.

The "GREEN" operating indicator LED's on the control box will determine which input is causing the E 04 error code.

  1. If the "HO/ALT ACTION" LED is lit, the hold open switch is turned on. Turning the "hold open" switch off will clear the error.
  2. If the "NORMAL/SEQ" LED is lit, one of the wall actuator switches is either stuck in the "on" position, or has been wired "normally closed" where it should be "normally open".

Once the constant activation is removed, the E-04 should clear and allow for normal operation.


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question
CTE Stuck Tamper Switch
lcn thru bolt
error codes list
lcn error codes
wave actuator switch