What does a Factory Default Reset (FDR) do for NDE locks?
FDR – will do the following functions:
• Erases audits
• Erases access control programming
• Sets reader configuration to as shipped
• Lock configuration delays to as shipped
• Clears Construction mode
FDR – will NOT:
• Remove or delete the NDE from an active ENGAGE account
• Remove firmware updates
NOTE:The RTE (RX) switch (inside lever) is required to be functional to initiate FDR mode
To FDR:
Open the battery cover. Press the button under the pin hole above the batteries.
Press and HOLD FDR button until you hear two beeps and 2 green LED blinks.
Turn the inside lever 3 times within 20 seconds-LED will blink red and lock will beep with each turn.
It is complete when you will hear one long beep.
Install cover and connect to lock.
Click here for the YouTube on resetting an NDE lock.
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.