What components are needed to convert a hard wired actuator button to a wireless actuator button?
To convert a hard wired actuator button to a wireless actuator button you will need the following components:
An RF transmitter.
The 8310-844 transmitter for the (4-1/2" or 6" round, and the 4-3/4 square) wall mounted switches (one for each actuator button).
The 8310-844J transmitter for the 1-1/2"x 4-3/4 (rectangle) jamb switches (one for each actuator button).
A plastic wall box.
4-1/2" round surface mount box, 8310-868S.
4-1/2" flush mount box, 8310-868F.
4-3/4" square surface mount box, 8310-867S.
4-3/4" square flush mount box, 8310-867F.
6" round surface mount box, 8310-869S.
6" square flush mount box, 8310-869F.
1-1/2"x 4-3/4" rectangle jamb surface mount box, 8310-819S.
1-1/2"x 4-3/4" rectangle jamb flush mount box, 8310-819F.
A weather ring.
4-1/2" round, 8310-800.
4-3/4 square, 8310-801.
6" round, 8310-802.
An 8310-865 receiver (one or more) for each power operator depending on the functional operation required.
To convert an RF actuator button to a hard wired actuator button, simply remove the RF transmitter an connect the hard wiring to the "Common" and "Normally Open" terminals on the the switch.
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.