Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

What command do you use on a GT-400 to retrieve Gateway information?

There are two GT-400 commands that you can use to retrieve network Gateway information in order to troubleshoot a problem with connecting to the host.  The two commands are:  "netstat -r" and "route -e"

 

Here is a sample of the information that is returned by each command.  The address listed following "default" is the Gateway address.

 

~ # netstat -r

Kernel IP routing table

Destination Gateway Genmask Flags MSS Window irtt Iface

192.168.0.0 * 255.255.255.0 U 0 0 0 eth0

224.0.0.0 * 240.0.0.0 U 0 0 0 eth0

default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0

 

~ # route -e

Kernel IP routing table

Destination Gateway Genmask Flags MSS Window irtt Iface

192.168.0.0 * 255.255.255.0 U 0 0 0 eth0

224.0.0.0 * 240.0.0.0 U 0 0 0 eth0

default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0

 


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.