Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

What causes am ME Series closer to creep shut (creeper)?

If an ME Series closer creeps shut or will not hold open,

  1. Verify proper voltage is being supplied to the closer, if correct
  2. Check the on/off switch. Verify the voltage on the 2 pin connector where the solenoid plugs in, if voltage present at the closer
  3. The closer has an internal part failure and would need to be replaced..

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question
closer fluid temperture
door will not stay open
EL device will not hold open
closer holder conflict chart
Doormat is opener not closing