Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Isonas RC-03 Readers - Enabling Wiegand Interface Module (WIM)

To enable WIM on an RC03, first ensure it is properly installed by following page 31 of the RC-03 Manual: Download RC-03 Manual

Then use ReaderTester Tool (from DBCrystal Software Package) or ReaderCommander to send a "Set Wiegand" Command to the reader.  There are three options:

  • Off
  • Raw_Wiegand
  • Wiegand_Plus_HID

Note: Wiegand_Plus_HID will be the most common selection.

 

Once the reader has wiegand enabled, it will report incoming weigand data as badge reads in Pure Access. Credentials can then be manually enrolled or enrolled by presentation depending on Bitmask and card data format.


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.