Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Is there a way to reset a 900 series power supply if there is no DC output?

You can try to reset a 900 series power supply by following the steps below:
1) Remove any load from the supply. This is any relay boards and anything wired into the DC outputs. 
2) Disconnect the AC from the supply.
3) Remove the 12/24VDC jumper and wait a moment.
4) Reconnect the 12/24VDC jumper.
5) Reconnect the AC
This should bring the DC back up. If not, the supply will need to be replaced. 


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.