Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Is it possible to cut a Zero automatic door bottom (ADB) ?

Resolution:

Following are considerations for cutting an Automatic Door Bottom (ADB):

Zero ADBs can be trimmed down in the field to better fit the opening.
Trimming must be done on the lock side of the door bottom only.
Do not trim the side of the ADB which has the adjusting brass nut.
The trimmed cut should allow at least 1” (25.4mm) from the countersunk set screw.

If you have any questions, contact Allegion support prior to cutting. 877-671-7011, option 2.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.