Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

I have a new AD200 with the latest firmware and after I connect my wires to the remote release button I still cannot get it to function properly.

You will need the following:
AD200 Series lock with main board rev F or later
Firmware that is AD.A.80 or later
Select "Storeroom" function in SUS on Edit Tab
Connect wired remote wires to latch bolt connector
The remote release function will only operate when the inside cover is properly installed.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.