Early Pro series locks did not have a CLR button on the main board as did the subsequent generation of the lock.
To reset one of these ea;y units follow the instructions below.
A. Disconnect batteries or power.
B. Push and hold any button on the keypad for about two seconds.
C. Wait approximately 5 seconds.
D. Reconnect the batteries/power and immediately proceed to the next step.
The green and red LEDs will alternately flash several times.
E. Immediately after the LEDs stop flashing, push the Star button three times.
The green and red LEDs will alternately flash several times again,
indicating the memory has been cleared – if not return to step A.
Note: If more than 3 seconds pass before the star button is pressed, the green LED
will blink only once, this indicates the memory was not cleared – return to step A.
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.