Link the WRI400 to a PIM400
The WRI400 and PIM400 must be linked for programmed credentials to function.
Link: Make sure the PIM400 is in link mode. Refer to the PIM400 User Guide for more information.
1 1 - Make sure power is connected to the WRI400.
2 2 - Remove the WRI400 cover.
3 3 - Press and hold the WRI400’s LINK button until the RX/TX LED blinks red and green (approximately 5 seconds).
4 4 - When linking is successful, the RX/TX LED will blink to indicate the quality of the RF link.
RX/TX LED Link quality
Solid green, fast green blinks, or green with very few red blinks Good link
Solid red or fast red blinks Poor or no link
• The WRI400 will fail to link if it is not in RF range of the PIM400. Refer to PIM400 and WRI400 manuals for location and distance specifications.
• Refer to Troubleshooting sections of PIM400 and WRI400 manuals for more information on linking.
5 - Once successfully linked to the PIM400, the WRI400 will signal tamper to the Access Control Panel until the WRI400 cover is replaced or the Tamper Switch is pulled out for diagnostics mode.
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.