How to Enroll a Discontinued Connected Keypad Deadbolt or Lever onto a Z-Wave Network

Looking to pair your Schlage Connected Keypad Lock (BE369, FE599) with a third-party hub? Follow the steps below to enable inclusion mode and successfully enroll your lock.

Important

  1. Refer to your home automation system's documentation or website for more information, then continue.
  2. A Security-Enabled Z-Wave controller is required to utilize all remote capabilities of your Schlage Keypad lock.

How to Enroll your BE369 and FE599:

  1. Review the instructions or app that came with your system controller to understand how to "Add Device".
  2. Once your Z-Wave Controller is in "Add" or "Inclusion" mode,
  3. Enter the 6-digit programming code.
  4. Press the Schlage button.
  5. Press 0
    If the Schlage button flashes green, the lock was successfully enrolled.
    If the Schlage button flashes red, the lock was not enrolled successfully. 
     

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.