How do you convert an ND80 to an ND70?

To convert a Schlage ND80 to a ND70 you can replace the outside Keycam, Spindle and outside Spring Cage or simply replace the Chassis and re-use your existing Lever trim.

IMPORTANT: You will need to verify the production date stamped on the outside Spring Cage.

Ordering Instructions:

  • Keycam N123-010 and Spindle N523-013
  • Chassis and Spring cages: ND70LD LLL 626 LLL LLL, lever chassis
For post February 2023 Production: 
 
Outside Spring Cage: The ND80 produced after February 2023 will have a fixed outside lever casting part number 47261997 that replaced the standard outside Spring Cage part number N523-218. See image below:
 
 

For Pre-February 2023 production: 

Outside Spring Cage: The ND80 produced pre-February 2023 will have an active Spring Cage stamped N523-218, and a pre-February production date stamp. See image below:

 

 

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.