How do I switch the Aeotec Smart home hub from ethernet to Wi-Fi?

You may follow the steps below if you want to connect your Smart Home Hub to Wi-Fi after you have finalized installation. It is always preferred to set up your hub using an Ethernet connection, and then connect it to Wi-Fi afterward.

NOTE - In order for Wi-Fi to become visible, you must remove power from your hub. Your hub must be marked as "Offline" before you continue these steps.  

Steps.

1. Disconnect power to your Smart Home Hub and wait for your hub to go "Offline".
2. If you previously had your Smart Home Hub connected to Ethernet, make sure that you have the ethernet cable disconnected now.
3. Open SmartThings app
4. Locate the Hub in your SmartThings device list, if it isn't listed "Offline" yet, wait for your hub to go offline. 
5. Tap on the Hub tile to open up your hubs page.
6. Tap on More Options (3 dot icon) at the top right.
7. Tap on "Information".
8. Tap on "Update Wi-Fi information".
9. Connect your Smart Home hub to power. 
   • Regardless of the LED state at this point (blinking blue, solid blue, or other LED colors, push forward with step 10 (next step).
10. Press and hold the RESET button on the back of your hub, when the LED lights up yellow, release the reset button. 
11. Follow the on-screen instructions to set up your Wi-Fi. 
12. Scan the QR Code / or manually input the SN code. (Both the QR Code or SN code are located under the hub). 
13. Press "Connect"
14. Select your Wi-Fi and enter its password.