1.
Remove
the inside top cover.
2.
Disconnect
the RTX switch from the circuit board.
3.
Set
your meter to ohms and connect to the disconnected harness leading to the RTX
switch below (not at the PCB).
4.
Turn
the lever and hold. You should see about 0.1 ohms which indicates that there is
continuity and the RTX switch is working.
5.
If
you get no reading or out of limits, the RTX switch will need to be replaced.
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.