Locks equipped with keypads can be identified as KC-2 by pressing the “*” key five (5) times. After the fifth keypress, KC-2 locks will respond by flashing the green LED twice. Older KC locks will not flash the LED.
KC-2 locks equipped with keypads can be reset to factory defaults by this method:
Removing a battery and holding the “*” key down while reinstalling the battery.
KC-2 locks do NOT have the following default codes:
135135 Toggle
9115 Freeze/Lockout
Battery voltage can be read on unprogrammed or manually programmed KC-2 locks equipped with keypads:
Enter: Programming Code * 11 **
The LEDs blink the voltage; red for volts, green for tenths of a volt. For example, 6 red blinks plus one green blink equals 6.1 volts.
Note that this feature does not work on computer-programmed locks, as manual programming functions are disabled.
KC-2 locks do not have a battery-backed real-time clock, and will begin to lose time after four (4) minutes of having the batteries removed.
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.