Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

What is the minimal wiring to bench test a Chexit device?

Resolution:

FOR TESTING PURPOSES ONLY

The following wiring can be used to verify that the device will arm and alarm.
The FA Connection (a Normally Closed Fire Alarm Dry Contact between the Yellow and Red wires of the main Chexit cable) is required to meet applicable codes.
Therefore, do not leave the device wired as described below after testing.

Red and Black to power. Red is DC+
For bench testing: Tie Orange, Yellow, and Green wires to the Red (DC+ / Common)

After testing that the device will arm and alarm, follow the applicable wiring diagram in the Installation Instructions.
Reference

Von Duprin Chexit (New Design) Wiring & Installation Instructions - For device purchased on or after 8-24-2015 for the motor driven Chexit devices manufactured since 8/24/2015.
Von Duprin - Discontinued Old Style CX33A/35A CX98/99 Chexit Installation Instructions for the older solenoid driven Chexit devices manufactured before 8/24/2015.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.