Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
what is driver for small format AL series
”
RELATED FAQS
Question
Answer
What is the part number for the SFIC tail piece for a W lock?
Resolution:
Q330-168 SFIC Tailpiece (throw member for levers) Q330-169 SFIC Tailpiece (throw member for knobs) :
Schlage AL small format spacer installation requirements.
Resolution:
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...:
What is the part number for the full size core driver for the ND series?
Resolution:
The ND-Series FSIC driver is part number N523-127.:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
What replaced the A700-009 driver?
Resolution:
The A700-009 driver was obsoleted August 2005 and was replaced with the A700-039 driver and A700-041 finished cap.:
New FSIC driver info for the AL locks.
Resolution:
The new AL FSIC driver part number is A700-052. This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring. Th...:
What is the part number for the SFIC driver on the AL locks?
Resolution:
The small format core throw member for the AL locks is C604-381.:
Why can't a new spring cage or driver be installed on an older AL lock?
Resolution:
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert. Spring cage and driver replacements for AL locks manufactured before this design ...: