Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Vertical rod adjustment falcon panics ”

RELATED FAQS

Question
Answer
VERTICAL ROD PANIC DEVICE
VRPD; FEH
Can the XX-V, 19-V, 24-V or 25-V extension rod be used on the bottom rod?
The extension rod could be used either on the top or bottom rods.
What is the correct Schlage cam # for 718C for a concealed vertical rod device?
Devices built After 2/28/2011: Use a 1 1/8" - 1 1/4" mortise cylinder with straight narrow cam. (Cam profile same as the Schlage B520-731, see table below for part numbers) Devices built Befo...
 Modular 1-1/8"  Modular 1-1/4"  SFIC and FSIC  Non-Modular Non-IC Conventional  Non-Modular Non-IC Everest Primus  B520-730  B520-731  B520-2...
Where is the template for the 718 trims made after 2/28/2011 for Falcon/Monarch concealed vertical rod devices?
See the installation instructions 718 for -C devices.
Templates for current 718 series trim can also be found on Falcon website
FIRE EXIT HARDWARE
FEH, F, Exit Device (rim panic, mortise panic, vertical rod panic, panic device)
TOP LATCH
Vertical Rod latch that secures a panic device to the top frame
How to adjust the 9847/9947 or 9848/9948 rod adjustment?
See the link to a video instruction, Concealed Vertical Rod Exit Device Adjustment.Manual steps:Open door and release top latch bolt by inserting a screw driver in the hole at the top of the d...
What would cause an EL device to pull and release?
If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...
Why does the QEL cycle 3 times with a solid red led and does not work?
Improper mechanical adjustment or QEL calibration could cause the QEL cycle three times with solid LED and not work. First check mechanical adjustment on vertical rods or mortise lock device and co...