I can not get my older lever apart

RELATED FAQS

Question
Answer
The Von Duprin 7500 mortise lock body ships in the NL mode.  Either the function of 7500 lock body has not been changed to the Classroom function or the NL Drive screw is not all the way down. Step...
  Tips for changing the function: The NL Drive screw will not be visible when lock body is set to Classroom function There is locktite on the screw that makes it seem like its turned down enou...
See 24 and 25 series trim section in the Price Book.
The only Falcon Doromatic device with a lever trim option trim is the 1790 device.
Beginning January 2, 2013 Schlage will offer the Latitude (LAT) and Longitude (LON) levers in the 629 and 630 stainless steel finishes.
The lever removal tool can be used to remove levers in both the ND and the L Series mortise locks.
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project.  This tool can be used for Schlage ND-Series ...
Frascio is a company that provides decorative lever sets for many of Allegion products.  More information can be found on their web site at WWW.frasciointernational.com.
The E7500 electric mortise lock body supplied on E98/9975 devices require active trims (L, L-BE, TP, TP-BE, K, or K-BE) to retract the latch after the electronic lock body unlocks.
The old D-Series Lever used a standard lever insert similar to the pre-2002 AL-Series standard lever insert.  The old D Lever insert was smaller than the AL and the two were not comp...
The blue lever tool remover, 24002693, is not shipped in every box. The existing wire spring lever removal tool will be included in every box.