finger guard discontinued

RELATED FAQS

Question
Answer
The LCN Safety (Finger) Guard was a heavy duty vinyl product that covered the opening between the door and frame, where most hand injuries occur. The LCN 750 Safety (Finger) Guard was the pul...
Replacing the battery on the 2670 should not cause the unit stop working. Make sure the spring that provides tension on the plastic finger is not bent out. The spring should be at a 90 degrees...
The Von Duprin 2670 Guard X does not have a spring loaded latch bolt, it is a dead bolt and will not operate with any electric strikes.
The 2670 Guard X uses a standard rim cylinder for either push side or pull side.  The rim cylinder can be installed to the outside of the opening with an offset pull to operate the 2670 Guard X d...
The 2670 Guard X device can't be cut down to fit doors less than 3 feet.  This device is designed to fit doors 36"-48" door width.
Exit devices are not designed for exterior application. If used in an exterior applications then a powder coated finish on the 33/35 and 98/99 series are recommended for exterior applications. ...
The RGO (rod guard only) is 36" long x 1-5/8" wide.