How many P & D (Pierce and Dimple) holes are in a frame?

The following are quantities of EMA anchors (pierce and dimples) based on range of frame height:

 Quantity  Nominal Frame Height
    2     1' 0" - 2' 9"
    3     2' 9 1/8" - 3' 11"
    4     3' 11 1/8" - 7' 1"
    5     7' 1 1/8" - 8' 9"

    6

    8' 9 1/8 - 10' 0"
    7

   10' 0 1/8" - 12' 1"

  1. These quantities are the same for both label and non-label openings. For jamb depths 3" through 9 1/8" frames have a single dimple, for jamb depths 9 1/4" and above there are two (2) located side by side at each location.
  2. The bottom dimple is located at 2 1/2" from bottom of frame, this eliminates the need for an additional base anchor.

For labelled applications - These P & D are solely designed for use into masonry walls systems, attached using 3/8" diameter expansion bolt. Installing into any other wall assembly using any other attachment must be approved by others, if label must approved by AHJ.


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question