How do you reset an AD-200 back to default?

Many problems with AD-series locks can be resolved by performing a Factory Default Reset (FDR).  This process will clear the memory and any stored configurations, re-enabling default user codes (in AD200s) and re-enabling the ability to use construction mode.  

To perform an FDR on an AD-series lock:

1.     Remove the inside top cover of the lock.  This will expose the main board and activate the tamper switch.

 

2.     On the front side of the lock, press and hold the “Schlage” button for 10 seconds until 2 beeps sound and the green light on the “Schlage” button flashes.

 

3.     Immediately press the Interior Push Button (IPB, the button on the white pedestal on the main board) 3 times.  1 beep will sound with each press of the IPB.

 

After several seconds, the beeper will sound and the “Schlage” button will light green for 1 second, indicating that memory has been cleared.

Note: An FDR cannot be performed if an HHD is plugged into the lock. 


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask