Category: Electromagnetic Locks

(Results from 21 to 30)
How much pressure is required on the M490DE to trip the alarm?
15 pounds...
Schlage Commercial » System Components » Electromagnetic Locks
M490DE is not relocking after power is restored
Confirm SW2 – 4 is enabled  ( enables lock to re- energize)   ·         IF M490DE still does not relock, check :   Is there ...
Schlage Commercial » System Components » Electromagnetic Locks
My 320M is getting very hot
Confirm if the 320M is installed in a wood frame, if so, the power supply needs to be a 12v filtered and regulated.   ·         24 volts should not be u...
Schlage Commercial » System Components » Electromagnetic Locks
Can the M490DE-2 provide separate delayed egress for each door?
No, the delay comes from the Master lock side and will release both doors simultaneously. You should be installing (2) M490DE mag locks if independent operation is required.  This way ...
Schlage Commercial » System Components » Electromagnetic Locks
Does Schlage have a Shear Lock Mag with DE?
No.  The only Shear Lock available is a GF3000 but there isn't a Delayed Egress option....
Schlage Commercial » System Components » Electromagnetic Locks
For the M490 angle brackets, what size tap would be used for the metal screws?
Metal screws for the angle bracket is #12-24...
Schlage Commercial » System Components » Electromagnetic Locks
On the gf3000-BRD, how much space is needed to install the armature on the door?
At the bottom rail must have 1 3/4" or more room for the armature assembly of the GF3000BRD....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » GF3000 Series
Are the Locknetics Mag Locks WMG600 and 1200 water resistant?
Yes, they are water resistant-   UL 1034 rated for indoor and outdoor use...
Schlage Commercial » System Components » Electromagnetic Locks
Installation instructions for the WMG600 and 1200 series mag locks
Please see attached...
Schlage Commercial » System Components » Electromagnetic Locks
M490DEP tied to a FA, if the fire alarm is activated, should it release the maglock without going into an alarm? Once fire alarm is reset and the door is closed, the maglock should energize without resetting the maglock?
Yes, if dipswitch 4 is on....
Schlage Commercial » System Components » Electromagnetic Locks

Support by product