Schlage offers the AL170 single dummy trim, but for applications where a double dummy is needed you can install two AL170 dummy trims back-to-back. Each AL170 is shipped with a threaded rod (part ...
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...
The new AL FSIC driver part number is A700-052.
This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring.
Th...
Incorrect timing of the lock can cause the outside lever to retract the latch when raised up. See instructions here (Step 16 and 17) to time a T351, T381, T561, and T571. Also applies to the same...
To verify the timing on a T561, function test the outside lever after locking it.
To lock the key should only rotate 180 degrees (Not 360 degrees as Schlage does)
A properly timed lock will n...
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert. Spring cage and driver replacements for AL locks manufactured before this design ...
Typical installation by an experienced Schlage L lock installer on a door correctly prepped for the Schlage L-Series function could take 10 to 20 minutes. Many outside variables can change the amo...