Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
old d-series tailpiece
”
RELATED FAQS
Question
Answer
What is the length of a Schlage rim cylinder?
Resolution:
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...:
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...:
Will Falcon B locks prepped for BD accept a 6 or 7 pin core?
Resolution:
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for bo...:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
Did the H-Series deadbolt and linkage change?
Resolution:
As of May 23, 2011 the Schlage H-Series is assembled with the Schlage B500-Series deadbolt and a new linkage. If the deadbolt is being replaced for a lock manufactured prior to May 23rd, 2011...:
What is the part number for a key in lever tailpiece for the ND lock?
Resolution:
For modular designs: All functions except ND85 the tailpiece part number is N523-022. The ND85 tailpiece part number is N523-123. For non-modular designs: All functions except ND85 the t...: