33/3547 INS-2
One longer ratchet release finger
Two longer fingers to connect the center case to the vertical rods
33/3547 INS-4
One longer ratchet release finger
Two longer fingers to connect the center case to the vertical rods
33/3549 INS-2
Longer lift finger to connect the center case to the center slide assembly
Longer mounting screws for the center slide and top and bottom latches
33/3549 INS-4
Longer lift finger to connect the center case to the center slide assembly
Longer mounting screws for the center slide and top and bottom latches
98/9947 INS-2
One longer ratchet release finger
WDC rod set with INS straight links to connect the center case to the vertical rods
990 series trim and 991K/991K-BE and 996L/996L-BE not compatible with this. Trim finger and lower 990 mounting stud obstructed by rods.
98/9947 INS-4
One longer ratchet release finger
Old style straight bottom rod without an offset
(Both top and bottom rods can pull close toward the inside skin of the door and allow rod fingers to pass through 1/4” panel)
98/9949 INS-2
Longer lift finger to connect the center case to the center slide assembly
Longer mounting screws for the center slide and top and bottom latches
98/9949 INS-4
Longer mounting screws for the center slide and top and bottom latches
Note: When ordering an exit device with the INS option from the factory, the special parts described above substitute the standard parts.
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.