What diameter opening is needed for the Allegion Connect Harness?

The Allegion Connect harness insulation is 3/8" in diameter. The Molex connector at its widest point is 0.633" (just over 5/8").

  • Harnesses with connectors on both ends would require a minimum opening with a 3/4" diameter
  • Harness with connectors on one end and pinned wires on the other (ex. CON-32P) would require a minimum opening with a 1/2" diameter. The end with the connector would not fit through the opening. NOTE: Loose Molex connectors are provided with the harness for inserting the pinned wires in the field
  • Harnesses with connectors on one end and stripped wires on the other (ex CON-6W) would require a minimum opening of 3/8" diameter. The end with the connector would not fit through the opening

NOTE: A Molex pin extractor can be used to remove the pins from the connectors. 


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.