How to pair the Schlage Connect Smart Deadbolt with Vivint

Resolution:

Programming steps may vary depending on model, To add new Vivint hub to access the Schlage Connect Smart Deadbolt, follow the instructions at Vivint Support: https://support.vivint.com/s/article/Go-Control-Panel-Add-Devices

You can also try following the instructions listed below.

Before anything is done, Ensure the control panel being used has been unlock by vivant.
This can be done by calling into customer service or going to support.vivant.com and chatting with an expert. The conversation is as easy as " I want to unlock my vivant control panel" 

Exclusion:

• Click on the control panel
• Click on the 3 dots at the bottom right corner
• Click on software version
• type in code: 2203
• Click Smart Home Devices
• Click on Z-Wave
• Click Remove Node
• Go through the device exclusion process (Schlage button - Programing code - 0)
• You should hear 3 beeps from the panel

After exclusion has been done it will stay on the same screen so just pick add node if that is the case

Inclusion:

• Click on the control panel
• Click on the 3 dots at the bottom right corner
• Click on software version
• type in code: 2203
• Click Smart Home Devices
• Click on Z-Wave
• Click Add Node
• Go through the device exclusion process (Schlage button - Programing code - 0)
• You should hear 3 beeps from the panel