How do I couple a CO-200 lock using a StratIS Sphere tablet to program the lock?
Connect the
Stratis USB cable to the CO lock
From the StratIS tablet’s Door Operations
menu select the option for 'Connect to CO/CT Lock'.
From CO/CT Lock menu,
select 'Set Coupling Pass' menu and perform the following steps:
In order to
commission the lock, it must be placed into "bootlader" mode.
While
connected to the lock, follow these instructions and then press 'Commission
Lock' below.
Turn the key in
the lock as far as it will go to the right and hold it in place.
While holding the
key, press the Schlage button three times. It should start flashing amber.
Turn the key to
the left a few degrees and release it
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.