Category: Automatic Operator

(Results from 21 to 30)
What are the power requirements for the 8310-865 (433 MHz) receiver?
The input voltage for the 8310-865 (433 MHz) receiver is 12-24 VAC/VDC +/-10%, the current draw is 250mA (0.25A)....
Door Controls » Automatic Operator » 8310 Series » LCN
Is the 8310-849 Door Sequencer still available?
The 8310-845 is now a combination "Time Delay Relay / Door Sequence" module. In 2010 the separate 8310-845 "Time Delay" module and 8310-849 “Door Sequencer” module were combined into a "common...
Door Controls » Automatic Operator » 8310 Series » LCN
Where do the wires of the 8310-865 receiver connect on the Falcon 8200 series operator?
The 8310-865 RF receiver connection to the Falcon 8200 operator are: RED and BLACK power wires on the receiver connect to the 12V AC terminals on the Falcon operator. The WHITE wire from the COM term...
Automatic Operators » Electromechanical » 8200 Series » Falcon | Door Controls » Automatic Operator » 8310 Series » LCN
Why would a 8310-806K be used in conjunction with a 4600 that has a on/off hold open switch?
The 8310-806K/R is used when a remote OFF/AUTO/HOLD OPEN is required and is normally used with a 4630/4640 CS (concealed switch) unit.For wiring diagram see here....
Automatic Operators » Electrohydraulic » 4630 Series » LCN | Automatic Operators » Electrohydraulic » 4640 Series » LCN | Door Controls » Automatic Operator » 8310 Series » LCN
What is a 7910-967?
The 7910-967 is a part number for a discontinued RF actuator. It was replaced by the 8310-3856WS RF actuator. The new 8310-3856WS requires the use of an 8310-865 RF receiver. When replacing the old...
Door Controls » Automatic Operator » 8310 Series » LCN
What components are needed to convert a hard wired actuator button to a wireless actuator button?
To convert a hard wired actuator button to a wireless actuator button you will need the following components: An RF transmitter. The 8310-844 transmitter for the (4-1/2" or 6" round, and the 4-3...
Door Controls » Automatic Operator » 8310 Series » LCN
Will a new RF "programmable" transmitter work with an older RF receiver that has "dip switches"?
The newer "programmable" RF transmitters/receivers will not work with the older "dip switch" transmitters/receivers. The frequency and coding are different....
Door Controls » Automatic Operator » 8310 Series » LCN
What is the average battery life on wireless actuators?
On average, the battery life on the wireless actuators will be 9 months to 1 year for most installations. Extreme (cold) conditions may reduce battery life....
Door Controls » Automatic Operator » 8310 Series » LCN
Can a magnet, or sentronic device, be released and close the door from a button at a desk?
If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiring per ST 1...
Door Controls » Automatic Operator » 8310 Series » LCN | Door Controls » Fire Life Safety » Fire/Life Safety Series » LCN | Door Controls » Fire Life Safety » SEM Series » LCN
Can a 8310-818 be used outside?
Exterior mounting of the 8310-818 series actuators is not recommended. The 8310-818 series actuators are designed to be jamb mounted on the frame. With that installation, the person will have to sta...
Door Controls » Automatic Operator » 8310 Series » LCN