Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Why doesnt el stay retracted ”

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

What is needed to keep the EL device retracted all day?

Resolution: To keep the Von Duprin electric latch retraction EL or QELA exit device dogged (retracted) all day, have your access control, Key pad, key switch, fire alarm contact or any other signals ...:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

What would keep the vertical rod exit devices top latch from being held retracted in the open position?

Resolution: Following exit devices 2227/F, 33/3527A/F, 33/3547A/48A/F, 98/9927/F and 98/9947/48/F have similar rod adjustment procedures. All top latches control the bottom latch assemblies. When do...:

Why is my latch not retracting when I depress the push pad on an XP98/99 device?

Resolution: Pushing on the push bar or activating the EL/QEL or the trim on Von Duprin XP98/99 exit device does not retract the latch, it releases the latch only. Door must be pushed or pulled when device o...:

Why is the 2390 top latch not staying retracted when dogged?

Resolution: Most likely need to length the top rod so latch can engage it's internal latch retention state. See 2390 Instructions for adjusting rod lengths.:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Why doesnt el stay retracted ”

RELATED FAQS