what is tallpiece in cylinder

RELATED FAQS

Question
Answer
Schlage offers Falcon Retrofit cylinders to fit many of Falcon's locks.  Table 1 below contains part number for T series locks.  Table 1 - Falcon retrofit cylinders  
The 40-100 is a multiple tailpiece pack with a pre-assembled, 0-bitted, key-in-knob cylinder.  The kit includes the following: (1) Pre-assembled cylinder 0-bitted, less tailpiece 40-100 (...
The pack is available in all keyways, Everest and Classic families including restricted keyways except Primus. 
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece.  Because of allowable tolerances for each part the average length is l...
Standard Schlage rim cylinders will fit a total thickness of door and projecting trim of 3 inches, this includes a minimum of 3/8" of engagement of the tailpiece into the exit device.  See ima...
For total thickness measurements larger than 3 inches see the special cylinder offerings in Pricebook.  Specify the part number and include the total thickness.  We do not offer the ...
B502-899 is the tailpiece for both the SFIC and standard rim cylinders.
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders.  Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces
The B220-001 is an FSIC rim tailpiece and driver.
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted.    This will occur if the outside spindle (square post) is install...
Only the Schlage ND-Series can be prepped to accept non-Schlage cores. All designs are supplied with the appropriate tailpiece Non-Schlage cores are NOT included Lever designs available vary d...
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.