tools for al series

RELATED FAQS

Question
Answer
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...
Changing the plunger assembly on the AL-Series requires disassembling the chassis.  Refer to Plunger Assembly Instructions for guidance.
The castlenut wrench material was changed from steel to a very strong polymer.  The new part number is 40-017.
 See the attached Technical Note for instructions on saving a "Device Template" FROM a device or loading TO a device, Device Template Tech NoteOn the SUS/HHD go to the LOCK Properties tab, and sele...
Only the lever return spring is available.
Related solution: What is the part number for the lever return spring for the old M series mortise lock?
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig.  When the jig changed to...
Within CDT (Configuration and Demonstration Tool), the usable COM port range is 1 - 6.
The software will not allow higher COM ports to be used.
If your computer has set the COM port for the serial connection to higher than 6, the setting must be adjusted in device manager to a lower port to enable CDT to communicate with the PIM.
The A700-009 driver was obsoleted August 2005 and was replaced with the A700-039 driver and A700-041 finished cap.
Schlage offers the 10-042 Electric strike, 1 1/4" x 4 7/8", 606 and 626 finish only. Related solution: What are the current and voltage requirements of the 10-042 strike?