REMOVE SPLIT KEY

RELATED FAQS

Question
Answer
With split key construction keying there are two ways the construction insert is retained in the cylinder so that it won't fall out the back end of the plug, see Figure 1.  The&nb...
Split key systems are delivered in the highest level section on the key tip (insert): L - obverse or classic Y - reverse 0000 - Paracentric ZZZZ - Quad D000 - restricted Everest C000 - open...
A control key is required to install or remove an interchangeable core from a housing or lever. The control key is identified by having "CONTROL" stamped on the bow. How to install and remove an i...
The lever may be missing the slot feature for the core locking lug.  Verify slot is in place.
This is usually caused because the wrong tailpiece is being used on non-IC cylinders or the incorrect driver for IC options. Use the below descriptions to identify which they need.NON-IC: There are...
After rotating  the key to unlock the lock, you must return the key to its normal position to remove it. 
Most key blanks have to be ordered in multiples of 50. Exceptions listed below: Classic and Primus Large Bows Classic and Primus Access Bows All Control Keys All Emergency Keys Primus Locko...
This HandNet for Windows message appears only when a HandKey 2 connects to it for the first time.  During the uploading of users from the HandKey 2 to HandNet, the software verifies the user d...
The door handing determines the finish of the latch and strike. Left reverse and right reverse doors default to outside trim Left and right hand doors default to inside trim If lever an...
We do not offer a true night latch, storeroom or ANSI "03" function with this device. (Entrance by trim when latchbolt is retracted by key. Key removable only when locked.) This function would da...