Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Push open button nothing happens
”
RELATED FAQS
Question
Answer
What could cause a 9100 Series Benchmark operator not to open when the actuator is pushed?
Resolution:
If the 9100 Series Benchmark operator does not open when the actuator is pushed: Verify the unit has 120 volts applied to it. Verify the the power light on the control box is on. If not, check ...:
What would cause a 4600 operator to click a few times when the actuator is pushed, but not open the door?
Resolution:
If a 4600 clicks, but won't open the door: Verify proper connection of all the control box connectors. Verify correct manual operation of door. Verify actuator connections and any strike/maglo...:
AL-Series Plunger Assembly Instructions
Resolution:
Changing the plunger assembly on the AL-Series requires disassembling the chassis. Refer to Plunger Assembly Instructions for guidance.:
How to change switches on a 8200 Console to maintained or momentary?
Resolution:
To replace the pushbuttons, remove the switch connector from the console main board Then press the pushbutton from the inside of the panel face out through the hole. There will be some resist...:
Will the 25-R or 25-V work with Simplex trim?
Resolution:
The 25-R or 25-V device does meet the trim input requirements set by KABA for their trim so the two should be compatible. However, the KABA trim has never been tested in house for the Fa...: